VDS 200Q100
Output Range: -20 V to +80 V
Output Current: 0 A - 100 A, continuous
Peak Current: 300 A for 200 ms
Bandwidth: DC - 150 kHz full signal
Extended Envelope: -20 V - +80 V (80 A max.), 150 - 250 kHz (40 Vpp max.)
Supply Voltage: 3-phase 200/400 V ±10%, L1, L2, L3, PE
Dimensions: 19"/38 HU**)
Weight: 450 kg
General
- Source impedance: Zi =
- Operation: 4 - quadrant, bipolar operation
- Current limiter: 3x Imax: allows an inrush current of three times nominal current for 200 ms before the current limiter starts 3x ictrl: allows an inrush current of three times the programmed current for 200 ms before the current limiter starts Peak OFF: no inrush current above the set current value (not available for VDS 200Q10)
- Compensation: STD: DC - 40 kHz HF: DC - >=150 kHz CAP: DC - 3kHz
- Recovery: >90% of excursion within 25 us
- Output rise time: typ.
- Ripple voltage: Ur
- Control: Analog In
- Cooling: temperature-controlled air cooling
- Protection: Thermal-Magnetic Circuit Breakers Depending on VDS 200Q model
Trigger
- Automatic: Automatic release of the events
- Manual: Manual release of a single pulse
- External: External release of a single pulse
Output
- DUT Supply +/- : Safety laboratory or high current connectors
- Ext. trigger: 5-15 V TTL, BNC connector
- CRO Trigger: 5 V TTL-signal for oscilloscope
Interface
- Interfaces: USB, Ethernet (for optional AutoWave), IEEE 488, addresses 1 - 30
- Remote control: To connect an external signal generator (10 kohm): -10 V - +10 V / 0 - 150 kHz (180 kHz for VDS 200Q10)
Test Routines for Arbitrary Waves
- DC source: Depending on VDS 200Q model
- Functions: Sine Wave Sweep, Sine Wave (Cranking), Clipped Load Dump, Jump Start, GM 9105P Pulse 4, Drop and Jump pulse, External
- Standard test routines: ISO 7637, Pulses 2b and 4, ISO 16750-2
- Service: Service, Setup, Self test
Operating Environment
- Temperature: 10 - 40 °C
- Rel. humidity: 10 - 90 %, non-condensing
- Atmospheric pressure: 86 kPa (860 mbar) to 106 kPa (1,060 mbar)
