RF Current Probe Calibration Fixtures

Part of the test equipment required by most of the Bulk Current Injection test procedure specifications. Allows the user the quickly and easily calibrate the injection probe prior to performing compliance testing.

Designed for the IEC 61000-4-6 Ed 4.0, section 6.2.3.1 – 6.2.3.2 that states “…the increase of the transmission loss of the test jig, produced by the insertion of the Current Clamp, shall not exceed 1.6 dB”. This 1.6 dB requirement is verified by subtracting the insertion loss of the calibration fixture without the Clamp in place from the fixture insertion loss with the Clamp in place.

20 Hz–500 MHz

offers a frequency range of 10 kHz–400 MHz

For MIL-STD-461 CS114, CS115, CS116

Great way to keep your broadband Current Probes, and Injection Current Probes calibrated and up to date. Their rugged design ensures long life, and faultless operation over the wide calibration frequency range of 400 MHz- 1.5 GHz.

For Current Probes

The AH Systems CPF-531 Current Monitoring Probe Calibration Fixture is a great way to keep your broadband Current Probes, and Injection Current Probes calibrated and up to date.

Calibration Fixture for CLCI-100 Bulk Current Injection Probe, 10 kHz to 100 MHz

The Com-Power FCLCE-1000 is designed for use with the Com-Power CLCE-400 Emissions Probe.

Current Probe to 50kA: 0.01V/A +/-1%; max rms current 400A with usable risetime from 200ns

Calibration Fixture for MIL-STD-461

10 kHz to 500 MHz

e R&S®RT-ZM modular probe system addresses today’s probing requirements with a technically sophisticated, yet easy-to-handle solution. The various probing solutions meet the demands for high probing bandwidth and dynamic range in conjunction with the need for low capacitive load. The R&S®RT-ZM probe system includes probe tip modules for various measurement tasks and conditions. The probe tip modules can be connected to amplifier modules with bandwidths ranging from 1.5 GHz to 16 GHz.