CE marking is used to indicate that a product meets the European Union's (EU) standards for health, safety, and environmental protection. The CE mark is a requirement for the distribution of a variety of products in the EU. Meeting the safety requirements to receive CE marking is not a standard, but rather a legal requirement of the EU. When a manufacturer marks a product with the CE mark, they are declaring that it meets all of the legal requirements associated with CE marking. The CE mark allows products to be sold within the European Economic Area (EEA) without restrictions.
Rent or purchase equipment to certify your electrical product with the CE Mark from Avalon Test Equipment and Test With Confidence®.
Electronic and electrical equipment may be affected by voltage dips, short interruptions and voltage variations of the power supply. Dips and interruptions are caused by faults in the public supply network, in installations or by sudden large change of load. Testing to such phenomena is required to proof that electronic and electrical equipment do not fall into unsafe operation conditions. EM TEST offers a full range of simulators up to 3x690VAC, 100A and DC voltage capability of up to 600V.
The EM Test UCS500N7 Multifunctional Transient Immunity Simulator includes everything necessary to conduct fully compliant tests at levels that go far beyond common test requirements. Surge can be tested up to 7.0kV either according to IEC/EN 61000-4-5 or ANSI/IEEE C62.41. The UCS 500N7 offers an integrated Ringwave module (optional) as per ANSI/IEEE C62.41 and IEC/EN 61000-4-12 for ringwave tests on mains supply lines.
Haefely AXOS8 Compact Immunity Test System, 7 kV integrates all of the best features of several stand-alone test systems into one single economic solution. Standards: IEC/EN 61000-4-4, -4-5, -4-9, -4-11, -4-12
The Teseq CAS 3025 burst/EFT pulse verification kit has been specially designed to comply with the new requirements of IEC/EN 61000-4-4:2004 to enable EMC engineers to verify their burst/EFT test generators periodically.
The calibration kit CAS ISN is made for function tests and remeasurements on impedance stabilization network (ISN) for unshielded balanced pairs. Measuring parameters are common mode (CM) impedancence, phase angle, voltage division factor, decoupling attenuation (isolation) and longitudinal conversion loss (LCL). Impedance stabilization networks (ISN) are defined in CISPR 22 and CISPR 16-1-2.
CDN 3043 3-phase coupling/decoupling network series as a competitively priced, high performance extension to the NSG 3040 multifunction generator series.
Teseq’s new NSG 3040 is an easy-to-use multifunction generator that simulates electromagnetic interference effects for immunity testing in conformity with international, national and manufacturers’ standards including the latest IEC/EN standards.