Calibration Accessories

20 Hz–500 MHz

The calibration kit CAS ISN is made for function tests and remeasurements on impedance stabilization network (ISN) for unshielded balanced pairs. Measuring parameters are common mode (CM) impedancence, phase angle, voltage division factor, decoupling attenuation (isolation) and longitudinal conversion loss (LCL). Impedance stabilization networks (ISN) are defined in CISPR 22 and CISPR 16-1-2.

offers a frequency range of 10 kHz–400 MHz

The Teseq CAS 3025 burst/EFT pulse verification kit has been specially designed to comply with the new requirements of IEC/EN 61000-4-4:2004 to enable EMC engineers to verify their burst/EFT test generators periodically.

The Teseq CAS CDNE Calibration Kit provides measurements for CM impedance and phase angle, VDF, decoupling attenuation and DM impedance

Great way to keep your broadband Current Probes, and Injection Current Probes calibrated and up to date. Their rugged design ensures long life, and faultless operation over the wide calibration frequency range of 400 MHz- 1.5 GHz.

For Current Probes

The AH Systems CPF-531 Current Monitoring Probe Calibration Fixture is a great way to keep your broadband Current Probes, and Injection Current Probes calibrated and up to date.

Used to assist the test engineer in pointing the mounted test antenna towards the device under test.

Includes the load resistors and a set of adapter to connect the coaxial matching resistors appropriately to the DUT output port; 50 ohm

Calibration fixture for CMAD 20A, CMAD 20B, Lüthi FTC 40x15 E according CISPR 16-1-4

100 kHz to 100 MHz

Suitable for cat.6 (250 MHz)

ISO 7637 Automotive Pulse 3a & 3b Verification Kit

Measurements for common mode impedance, phase angle, voltage division factor, decoupling attenuation (isolation) and longitudinal conversion loss (LCL)