Close
You have no items in your shopping cart.

ENI 411LA, 10W Solid-State RF Amplifier

Manufacturer part number: 411LA
The Broadband Power Amplifier is a general purpose broadband amplifier capable of more than 10 watts of linear power output when driven by any laboratory signal or sweep generator from 150kHz to 300MHz.
PURCHASE
AvailableQTYPrice
New:   0
+ -
$0.00
Used:   0
+ -
$0.00Configurations
X

Available Configurations

The 411LA Broadband Power Amplifier is a general purpose broadband amplifier capable of more than 10 watts of linear power output when driven by any laboratory signal or sweep generator from 150kHz to 300MHz. An ultra linear Class A design, the 411LA will "boost" the output of any signal source by a flat 40dB and provide its full forward output power into any load impedance (from an open to a short circuit). Its output is a faithful reproduction of the input waveform for AM, FM, SSB, CATV, pulse, and other complex modulations. Although specified for linear power output only, the 411LA will typically supply more than 15 watts of power before reaching saturation. An integral power supply and cooling system permit operation over a wide range of temperature and AC line conditions.

  • Frequency Coverage: 150 kHz to 300 MHz
  • Gain: 40 dB
  • Gain Variation: ±2.5 dB
  • Maximum Class A Linear Output: 10W
  • Harmonic Distortion: All harmonics more than 23 dB below main signal at 10W output; lower at reduced power output.
  • Drive Source Requirements: Any signal generator, function generator, or oscillator capable of 1 mW of output into 50 Ω
  • Input/Output Impedance: 50 Ω
    • Input VSWR: 1.5:1 Maximum
    • Output VSWR: 2.5:1 Maximum
  • Power Requirements: 115VAC ±10%, 50-60Hz, 3.5A; 230VAC ±10%, 50-60Hz, 1.7A
  • Noise Figure: 10 dB Maximum
  • Typical 3rd Order Intercept Point +50dBm
  • Stability: Continuous operations into any load or source impedance.
  • Protection: Unit will withstand a +13dBm input signal (IV RMS) for all output load conditions, including short and open circut loads.
  • Front Panel Controls: AC Power On/Off
  • Front Panel Connections: RF input RF Output
  • Operating Temperature: 0° to 45° C
  • Cooling System: Forced Air
  • Size: 7.5" H x 9.5" W x 12.5" D; 19.05 x 23.13 x 31.75 cm.
  • Weight: 25 lbs; 11.3 kg.
  • Input Connector: Type BNC
  • Output Connector: Type BNC
  • Rack Mounting: 19 inch adaptors optional
Description

The 411LA Broadband Power Amplifier is a general purpose broadband amplifier capable of more than 10 watts of linear power output when driven by any laboratory signal or sweep generator from 150kHz to 300MHz. An ultra linear Class A design, the 411LA will "boost" the output of any signal source by a flat 40dB and provide its full forward output power into any load impedance (from an open to a short circuit). Its output is a faithful reproduction of the input waveform for AM, FM, SSB, CATV, pulse, and other complex modulations. Although specified for linear power output only, the 411LA will typically supply more than 15 watts of power before reaching saturation. An integral power supply and cooling system permit operation over a wide range of temperature and AC line conditions.